Filter
Top Products
Pacific Research Solutions RI-300e User Manual
Page 80
S-Cmd 56 PASSWORD FOR TELEPHONE INCOMING RING ACCESS
The telephone ring PASSWORD is used to start the ringing process on the repeater for incoming calls; also see S-Command 71,
incoming call mode. This password is only used in S-Command 71 modes 3 and 4. The controller will answer the telephone
and incoming ringing and provide an answer message to the caller. After this message, the ring password is used to start the
ring process on the repeater to let someone listening to the radio know that a caller is waiting on the telephone. The factory
default password is 343 and can be changed to another password, from 1 to 6 digits long. “C” is the only digit that cannot be
used in this password. Avoid using “A”, “B” and “D” as these digits are not typically available on standard telephones. For
more information, see section 15 of this manual under telephone interconnect.
SYNTAX: 56 [Telephone ring password]
READ BACK 56
STORAGE: RAM/EEPROM
PARAMETERS: Ring Password = 1 to 6 DTMF digits 0 through 9, * and #
DEFAULT: 343
EXAMPLE: 56 5419 The ring password is now 5419
S-Cmd 57 PASSWORD FOR TELEPHONE INCOMING CONTROL ACCESS
The telephone incoming control PASSWORD is used to access the User Command mode of the controller during an incoming
telephone call. This password can only be used in S-Command 71 modes 2 through 4. The factory default password is 654381
and can be changed to a password from 1 to 6 digits long. “C” is the only digit that cannot be used in this password. Avoid
using “A”, “B” and “D” as these digits are not typically available on standard telephones. When selecting a password, you
should avoid using one that is similar to a user command or the exact equivalent to an S-Command and its data. For more
information, see section 15 of this manual under telephone interconnect.
SYNTAX: 57 [Telephone control password]
READ BACK 57
STORAGE: RAM/EEPROM
PARAMETERS: Telephone password = 1 to 6 DTMF digits 0 through 9, * and #
DEFAULT: 654381
EXAMPLE: 57 3355 The control password is now 3355
S-Cmd 58 REMOTE SOFTWARE RESET
This command allows a method for reseting the controller remotely, just the same as if you were to do a power on reset.
You may also execute this command through a link (another attached RI-300 controller) or from the telephone. The serial
number of your controller is required to execute this command. You can find the serial number of the controller located on the
controller. Please make a note of the serial number and keep it in a safe place. Note: The read back command will NOT read
back the serial number, but rather, the Software Version resident in the controller.
SYNTAX: 58 [Serial number]
READ BACK 58 (Read back software version)
STORAGE: N/A
PARAMETERS: The serial number is 8 digits long.
DEFAULT: Your RI-300 Serial number
EXAMPLE: 58 87654321 Resets the controller software only. This example will not be your serial number.