Filter
Top Products
Settings and Printing
Network
NetworkMaintenance and Spec.
Setup in NetWare
60
Perform the following steps:
Step 1: Setting up the printer
Step 2: Setting up the Server
Step 3: Setting up the client
There are two printing modes.
[A] Print server (PSERVER) mode
[B] Remote printer (RPRINTER) mode
Before setting up, select a printing mode. For detailed information on these modes, refer to the
NetWare manual or Novell web site. You may need to check with your network administrator
which to select.
Setting the NetWare server is almost performed on the client. You must log on the server
using the supervisor privilege. Novell Client software must be installed in your computer prior
to setting up.
Step 1: Setting up the printer
When printing in Print Server mode, refer to procedures 1 to 12 of “[A] Using NDS - PSERVER
mode” on page 48 in “In NetWare 4.x / NetWare 5.x / NetWare 6”. However, click on the
Bindery Mode check box at step 10.
When printing in Remote Print mode, refer to procedures 1 to 12 of “[B] Using NDS -
RPRINTER (NPRINTER) mode” on page 53 in “In NetWare 4.x / NetWare 5.x / NetWare 6” .
In NetWare 3.x