Filter
Top Products
Administrator’s Guide for Polycom HDX Systems
1 - 4
Configuring with the Setup Wizard
When you power on your system for the first time, the setup wizard detects
the system’s IP and ISDN connections and leads you through the minimum
configuration steps required to place a call.
The setup wizard allows you to set a room password, which allows you to
limit access to the Admin Settings. The default room password is the 14-digit
system serial number from the System Information screen or the back of the
system.
You can run the setup wizard or view the configuration screens in either of
these two ways.
• In the room with the system — Use the remote control to navigate the
screens and enter information. You can use the number pad on the remote
control to enter text just like you can with a cell phone.
• From a remote location — Use a web browser to access the Polycom HDX
web interface. For more information about using the web interface, refer
to Accessing the Polycom HDX Web Interface on page 9-1.
Make sure you can recall the room password if you set one. If you forget the
password, you will have to reset the system, delete the system files, and run the
setup wizard again in order to access the Admin Settings and reset the password.
If Security Mode is enabled, the room password is required to access the Reset
System screen. If you forget the room password while the system is in Security
Mode, refer to Using the Restore Button on page 12-20.