Filter
Top Products
Administrator’s Guide for Polycom HDX Systems
2 - 6
Configuring the System to Use a Gateway
A gateway performs code and protocol conversion between H.323 (IP), SIP,
and H.320 (ISDN), so that users on different networks can call one another. If
the system is configured to use a gateway, you must also configure it to use a
gatekeeper.
To configure the system to use a gateway:
1. Go to System > Admin Settings > Network > IP > H.323 Settings.
2. Select two or three times and configure these settings on the Gateway
screen:
Points to note about PathNavigator’s Conference on Demand feature:
If your organization uses Polycom’s PathNavigator, you can use PathNavigator’s
Conference on Demand feature to place multipoint calls.
In order to place calls using PathNavigator, you need to:
• Register your Polycom HDX system with PathNavigator.
• Configure your Polycom HDX system to use PathNavigator for multipoint calls
(see Configuring the System to Use a Gatekeeper on page 2-4).
• Create a multi-site entry in the directory (recommended).
When using PathNavigator’s Conference on Demand:
• Once the call begins, users cannot add another site to the call — even if the site
was in the call originally.
• The MGC™ needs to have enough ports available to complete the call. If it does
not, the call disconnects.
Setting Description
Country Code Specifies the country code for the system’s location.
Area Code Specifies the area or city code for the system’s location.
Number Specifies the gateway’s number.
H.323 Extension
(E.164)
Specifies the extension that identifies this system for incoming
gateway calls.
The default H.323 Extension can be changed.