Polycom 14117800 Server User Manual


 
100 Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
If CISCO network: It is recommended to change the TOS priority - RTP Data to
0xb8.
3 In the TOS priority - Signalling field, type a TOS priority.
Depending on the network, it may be necessary to change the TOS priority.
Most networks: The default TOS priority is: 0x10
If CISCO network: It is recommended to change the TOS priority - RTP Data to
0x68.
For information about the TOS priorities used in your network, contact you system
administrator.
4 Click Reset (under Administration menu) to save your configuration.
The Master (Primary) KWS600v3 is now configured.
7.6.2 Configuring Sync Master
This section describes how to configure a Sync Master KWS600v3 in a multi-cell solution.
KWS600v3 primary and secondaries use the existing DECT air interface to synchronize to
each other on. One KWS600v3 is configured as a Sync (synchronization) Master in the
system. It is not necessary to configure what KWS600v3 the Sync Master should
synchronize to.
This section includes information about:
“Assigning a Specific IP Address (Sync Master)” on page 100
“Configuring LDAP Replicator (Sync Master)” on page 102
“Configuring DECT Master (Sync Master)” on page 103
“Configuring DECT Radio (Sync Master)” on page 103
For information on accessing the web based Administration Page, refer to “Accessing the
Web Based Administration Page” on page 79.
7.6.2.1 Assigning a Specific IP Address (Sync Master)
To assign a specific IP address to the KWS600v3, it is necessary to disable the DCHP
mode and then assign a specific IP address to the KWS600v3. The new IP address and
network address will be provided by the system administrator.