Polycom 14117800 Server User Manual


 
Regulatory Notices 211
KIRK Wireless Server 600v3 Installation and Configuration Guide
6 The product should be operated only from the type of power source indicated on the
instructions. If you are not sure of the type of power supply, consult your dealer or
local power company.
7 Do not overload wall outlets and extension cords as this can result in fire or electrical
shock.
8 Never push objects of any kind into this product through cabinet slots as they may
touch dangerous voltage points or short out parts that could result in fire, electrical
shock, or injury. Never spill liquid of any kind into this product.
9 To reduce the risk of electrical shock or burns, do not disassemble this product. Open-
ing or removing covers may expose you to dangerous voltages, dangerous electrical
current, or other risks. Incorrect reassemble can cause electrical shock when the appli-
ance is subsequently used. If the product need repair, consult your dealer.
10 This product does not support connections to outside plant.
11 Refer servicing to qualified service personnel under the following conditions:
AQ If liquid has been spilled into the product
BQ If the product has been exposed to rain or water
CQ If the product does not operate normally when following the operating instructions
in the manual. Adjust only those controls that are covered by the operation instruc-
tions. Improper adjustment of other controls may result in damage and will often
require extensive work by qualified service personnel to restore the product to nor-
mal operation.
DQ If the product has been dropped or cabinet has been damaged
EQ If the product exhibits a distinct change in performance
2 Avoid using telephone during an electrical storm. There may be a risk of electrical
shock from lightning
3 Do not use the telephone to report a gas leak in the vicinity of the leak
4 Do not place the unit near microwave ovens, radio equipment, or non-ground con-
nected televisions. These appliances may cause electrical interference to the base or
handset
5 The unit must be installed on a hard, plane surface and connected to a functional 120
volt AC power netadapter and plug the adapter into the power outlet
6 The system will not operate in the event of a blackout. Please keep a backup phone for
emergencies
Intrinsic safety
Do not install the unit in conditions where there is a danger of electrically ignited explo-
sions.
Exposure to sunlight, heat and moisture
Do not expose the unit to direct sunlight for long periods. Keep away from excessive heat
and moisture.