Filter
Top Products
Configuring KIRK Wireless Server 600v3 133
KIRK Wireless Server 600v3 Installation and Configuration Guide
Note: The LDAP Server tab is only available, if the Master is LDAP Server check box on
the Master tab is deselected.
Figure 72 Configuration Tool: LDAP Server tab
1 In the IP Address area:
• Deselect the DH
CP check box.
First time you power up the KWS600v3 it
acts as a DHCP client. To assign a
specific IP address to the unit, it is necessary to disable the DHCP mode.
•In the IP Address field, t
ype the IP address of the LDAP Server, provided by your
system administrator.
This IP address is now the default address when
accessing the LDAP Server.
•In the Network Mask field,
type the network mask.
•In the Default Gateway
field, type the IP address of the gateway.
•In the Host N
ame field, type the host name of the KWS600v3.
The host name consist of ip12
00- followed by the last three octets of the MAC
address of the KWS600v3 (to be found on the label on the rear of the KWS600v3).
Eg. ip1200-0f-01-9d
Note: When clicking t
he Get button, the system provides the host name
automatically. The Get button can only be used, if working online and if the IP
address is the specific IP address of the KWS600v3 in question and valid on the
whole network.