Filter
Top Products
Configuring KIRK Wireless Server 600v3 135
KIRK Wireless Server 600v3 Installation and Configuration Guide
Figure 74 Configuration Tool: Alt LDAP Server tab
1 In the IP Address area:
• Deselect the DH
CP check box.
First time you power up the KWS600v3 it
acts as a DHCP client. To assign a
specific IP address to the unit, it is necessary to disable the DHCP mode.
•In the IP Address field, t
ype the IP address of the alternative LDAP Server,
provided by your system administrator.
This IP address is now the default address when
accessing the alternative LDAP
Server.
•In the Network Mask field,
type the network mask.
•In the Default Gateway
field, type the IP address of the gateway.
•In the Host N
ame field, type the host name of the KWS600v3.
The host name consist of ip12
00- followed by the last three octets of the MAC
address of the KWS600v3 (to be found on the label on the rear of the KWS600v3).
Eg. ip1200-0f-01-9d
Note: When clicking the Ge
t button, the system provides the host name
automatically. The Get button can only be used, if working online and if the IP
address is the specific IP address of the KWS600v3 in question and valid on the
whole network.
2 In the LDAP area
:
•In the Primary field, t
ype the IP address of the primary LDAP Server.
3 Save
the configuration now or wait until you have finished configuring the whole
installation.