Filter
Top Products
140 Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
Figure 78 Configuration Tool: Secondary Settings dialog box
—In the Host Name field, type the host name. The host name consist of ip1200-
followed by the last three octets of the MAC address of the KWS600v3 (to be
found on the label on the rear of the KWS600v3). Eg. ip1200-0f-01-9d
Note: When clicking t
he Get button, the system provides the host name
automatically. The Get button can only be used, if working online and if the IP
address is the specific IP address of the KWS600v3 in question and valid on the
whole network.
—In the Sy
nc Master field, type the radio ID of the Sync Master. See your site
planner.
—In the Alt Sync Master field, t
ype the radio ID of the alternative Sync Master.
See your site planner.
Note: The rad
io ID of the Secondary KIRK Wireless Server is by default identical
to the last octet of its IP address. It is recommended not to change the radio ID.
— Click OK to
close the dialog box.
2 In the IP Settings (Shared) area:
• Deselect the DH
CP check box.
First time you power up the KWS600v3 it
acts as a DHCP client. To assign a
specific IP address to the unit, it is necessary to disable the DHCP mode.
•In the Network Mask field,
type the network mask.
•In the Default Gateway
field, type the IP address of the gateway.
3 In the Radio ar
ea:
•In the Master field, ty
pe the IP address of the Master KWS600v3.
•In the Alt Master
field, type the IP address of the alternative (Standby) Master
KWS600v3.
4 In the LDAP area
:
•In the Primary field, t
ype the IP address of the primary LDAP Server.
•In the Alt field, t
ype the IP address of the alternative LDAP Server.