Polycom 14117800 Server User Manual


 
136 Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
For more information about saving the configuration, refer to “Saving
Configurations” on page 141.
7.8.5 Configuring Sync Master
This section describes how to configure a Sync Master KWS600v3 in a multi-cell solution.
KWS600v3 primary and secondaries uses the exis
ting DECT air interface to synchronize
to each other. One KWS600v3 is configured as a Sync (synchronization) Master in the
system. It is not necessary to configure what KWS600v3 the Sync Master should
synchronize to.
In the Sy
nc Master tab you configure the Sync Master.
Figure 75 Configuration Tool: Sync Master tab
1 In the IP Address area:
Deselect the DH
CP check box.
First time you power up the KWS600v3 it
acts as a DHCP client. To assign a
specific IP address to the unit, it is necessary to disable the DHCP mode.
•In the IP Address field, type
the IP address of the Sync Master, provided by your
system administrator.
This IP address is now the default address when
accessing the Sync Master.
•In the Network Mask field,
type the network mask.
•In the Default Gateway
field, type the IP address of the gateway.