Filter
Top Products
MSI
149
MSI Command Format
BARCODE
MSI
n
; [
DIR
;] [
MAG
;] [H
n
[.
m
];] [BF
n;L
;] [DARK;]
SR; SC
[
(D)data field(D)
]
[PDF [;
LOC
] [;
FONT
]]
STOP
BARCODE The Bar Code command; enter BARCODE.
MSI Designates bar code type MSI; enter MSI.
n
Designates the type of check digit combinations for
the bar code. Replace
n
with one of the following
codes to specify the check digit.
A single-digit modulo-10 followed by a second
modulo-10 digit
B single-digit modulo-11 followed by a single
modulo-10 digit
C single-digit modulo-10
D single-digit modulo-11
DIR
Optional parameter that allows for rotating a
barcode. Enter CW for clockwise rotation. Enter
CCW or VSCAN for counter-clockwise rotation.
Enter INV for inverted rotation. If
DIR
is not
entered, the barcode is horizontally oriented.
MAG
Optional parameter to magnify (horizontally
expand) the bar code symbol. The magnification
default value is X1. As required for scanning, enter
a magnification value from Table 8 to increase the
magnification. Increasing the magnification adjusts
printed character density. You can also use XR or
XRD as defined on page 89.
H
n
[.
m
] Optional parameter to adjust the overall height
(vertical expansion) of the bar code symbol
(including the upper and lower 0.1-inch guard
bands and any human readable data). Height
adjustments are made in 0.1-inch increments; enter
H and a value from 3 through 99 to select height
adjustments from 0.3 through 9.9 inches. The
default value is 0.9-inch. The [
.m
] provides an
additional number of dots for the bar code height.
(Dots are in the current dot scale.)
Note If 0.3 inches is the selected height, the PDF cannot be
included.