Filter
Top Products
Execute Errors
269
65 CREATE page starting row PAGE SR out of bounds
When you specify the position of the page parameters with the
Page command in the Create Form mode, the row position
specified will place the page number above or below the
boundaries of the form. When this error occurs, the IGP will
automatically revert to the Normal mode.
66 CREATE page starting column PAGE SC out of bounds
When you specify the position of the page parameters in the
Create command, the column position specified will place the
page number outside the form boundaries. When this error
occurs, the IGP will automatically revert to the Normal mode.
67 CREATE STOP command missing
This error occurs when the IGP receives a new function
command, an End command, or a mode command without
receiving a Stop command. The IGP will continue to process
subsequent commands correctly.
68 Insufficient memory to store the SETUP program
No more room in the IGP/PGL memory exists for storing the
SETUP routine.
69 Insufficient memory to store the form
The directory is full, or no more room exists in the IGP memory
for another form. When this occurs, the IGP automatically reverts
to the Normal mode. To create space in the IGP memory, delete
forms that are no longer required.
Execute Errors
70 EXECUTE form count parameter FC error
This error occurs when the parameter specifying the number of
blank forms to print was entered incorrectly. When this error
occurs, the IGP will automatically revert to the Normal mode.
Form count can be from 1 through 65,535.
71 EXECUTE/DELETE form not found in the directory
An attempt was made to execute or delete a form which does not
exist in the forms directory. When this error occurs, the IGP
reverts to the Normal mode.
72 EXECUTE EVFU load error
This error is generated only during the Execute Form mode while
programming the EVFU. If more channels than lines per physical
page are specified during a load sequence, this error is
generated, and the IGP reverts to the Normal mode.
73 EXECUTE EVFU terminator invalid
This error is generated only during the Execute Form mode. The
EVFU LOAD is missing an END LOAD code. If the line terminator
cannot be deciphered, an error is generated, and the IGP reverts
to the Normal mode.