Filter
Top Products
46
Chapter 2 Command Codes
Configuration
Purpose Places the IGP/PGL in the Configuration mode, where changes
to any or all of the IGP/PGL configuration parameters via
software control can be made instead of from the printer control
panel.
Mode NORMAL
Format (cc)CONFIG
parameter;value
END
(cc) The SFCC.
CONFIG The Configuration command; enter CONFIG.
parameter;value
The parameter for which a configuration change is
desired, and the value associated with that
parameter. The available parameters and the
values associated with these parameters are listed
in Table 6.
END Terminates the CONFIG command; enter END.
Note A separate line is required for the CONFIG command, the
parameters and values, and the END command.
Note All CONFIG parameters except RESET must be followed by
a semicolon (;). Any CONFIG parameters not entered in
UPPERCASE and exactly as listed in Table 6 will result in
an Error 156. (Refer to the “Error Codes” chapter.)