SMC Networks 2.4GHz/5GHz Network Router User Manual


 
System Configuration
6-34
CLI Commands for the User Name and PasswordUse the
username and password commands from the CLI configuration
mode.
Upgrading Firmware
You can upgrade new wireless bridge software from a local file on
the management workstation, or from an FTP or TFTP server.
After upgrading new software, you must reboot the wireless
bridge to implement the new code. Until a reboot occurs, the
wireless bridge will continue to run the software it was using
before the upgrade started. Also note that rebooting the wireless
bridge with new software will reset the configuration to the factory
default settings.
Note: Before upgrading your wireless bridge software, it is
recommended to save a copy of the current configuration file. See
“copy” on page 7-41 for information on saving the configuration
file to a TFTP or FTP server.
AP(config)#username bob 7-19
AP(config)#password spiderman 7-20
AP#