SMC Networks 2.4GHz/5GHz Network Router User Manual


 
Command Line Interface
7-2
gateway if you are managing the wireless bridge from a different
IP subnet. For example:
After you configure the wireless bridge with an IP address, you
can open a Telnet session by performing these steps.
1. From the remote host, enter the Telnet command and the IP
address of the device you want to access.
2. At the prompt, enter the user name and system password.
The CLI will display the “AP#” prompt to show that you are
using executive access mode (i.e., Exec).
3. Enter the necessary commands to complete your desired
tasks.
4. When finished, exit the session with the “quit” or “exit”
command.
After entering the Telnet command, the login screen displays:
Note: You can open up to four sessions to the device via Telnet.
AP#configure
AP(config)#interface ethernet
AP(if-ethernet)#ip address 10.1.0.1 255.255.255.0
10.1.0.254
AP(if-ethernet)#
Username: admin
Password:
AP#