SMC Networks 2.4GHz/5GHz Network Router User Manual


 
System Configuration
6-42
CLI Commands for SNTP – To enable SNTP support on the
wireless bridge, from the global configuration mode specify SNTP
server IP addresses using the sntp-server ip command, then
use the sntp-server enable command to enable the service. Use
the sntp-server timezone command to set the location time
zone and the sntp-server daylight-saving command to set up a
daylight saving. To view the current SNTP settings, use the show
sntp command.
CLI Commands for the System Clock – The following example
shows how to manually set the system time when SNTP server
support is disabled on the wireless bridge.
AP(config)#sntp-server ip 10.1.0.19 7-29
AP(config)#sntp-server enable 7-30
AP(config)#sntp-server timezone +8 7-32
AP(config)#sntp-server daylight-saving 7-31
Enter Daylight saving from which month<1-12>: 3
and which day<1-31>: 31
Enter Daylight saving end to which month<1-12>: 10
and which day<1-31>: 31
AP(config)#exit
AP#show sntp 7-33
SNTP Information
=========================================================
Service State : Enabled
SNTP (server 1) IP : 137.92.140.80
SNTP (server 2) IP : 192.43.244.18
Current Time : 19 : 35, Oct 10th, 2003
Time Zone : +8 (TAIPEI, BEIJING)
Daylight Saving : Enabled, from Mar, 31th to Oct, 31th
=========================================================
AP#
AP(config)#no sntp-server enable 7-30
AP(config)#sntp-server date-time 7-31
Enter Year<1970-2100>: 2003
Enter Month<1-12>: 10
Enter Day<1-31>: 10
Enter Hour<0-23>: 18
Enter Min<0-59>: 35
AP(config)#