SMC Networks 2.4GHz/5GHz Network Router User Manual


 
Command Line Interface
7-84
pppoe lcp echo-interval
This command sets the Link Control Protocol (LCP) echo interval
for the PPPoE tunnel.
Syntax
pppoe lcp echo-interval <interval>
interval - The interval between sending echo requests.
(Range: 1-60 seconds)
Default Setting
10
Command Mode
Interface Configuration (Ethernet)
Command Usage
Echo requests are used to verify the integrity of the link
through the PPPoE tunnel. Devices at either end of the link
can issue an echo-request. Devices receiving an
echo-request must return an echo-reply.
If a link is busy with large data transfers, the echo-reply may
not be issued in a timely manner causing the link to timeout.
If you experience this kind of problem, try extending the
echo interval or timeout.
Example
Related Commands
pppoe lcp echo-failure (page 7-85)
AP#(if-ethernet)#pppoe lcp echo-interval 30
AP#