Filter
Top Products
Command Line Interface
7-50
Client MAC addresses can also be used for authentication on the
access point. For local MAC authentication, first define the default
filtering policy using the address filter default command. Then
enter the MAC addresses to be filtered, indicating if they are
allowed or denied. For RADIUS MAC authentication, the MAC
addresses and filtering policy must be configured on the RADIUS
server.
Command Function Mode Page
802.1x Configures 802.1x as disabled,
supported, or required
GC 7-51
802.1x
broadcast-key-
refresh-rate
Sets the interval at which the
primary broadcast keys are
refreshed for stations using 802.1x
dynamic keying
GC 7-52
802.1x session-key-
refresh-rate
Sets the interval at which unicast
session keys are refreshed for
associated stations using dynamic
keying
GC 7-53
802.1x
session-timeout
Sets the timeout after which a
connected client must be
re-authenticated
GC 7-54
802.1x supplicant Sets the supplicant user name and
password for the access point and
enables the feature
GC 7-60
address filter default Sets filtering to allow or deny listed
addresses
GC 7-56
address filter entry Enters a MAC address in the filter
table
GC 7-57
address filter delete Removes a MAC address from the
filter table
GC 7-58
mac-authentication
server
Sets address filtering to be
performed with local or remote
options
GC 7-59