Filter
Top Products
System Logging Commands
7-23
show version
This command displays the software version for the system.
Default Setting
None
Command Mode
Exec
Example
System Logging Commands
These commands are used to configure system logging on the
wireless bridge.
AP#show version
Version v1.1.2.1B05
AP#
Command Function Mode Page
logging on Controls logging of error messages GC 7-24
logging host Adds a syslog server host IP address
that will receive logging messages
GC 7-24
logging console Initiates logging of error messages to
the console
GC 7-25
logging level Defines the minimum severity level for
event logging
GC 7-25
logging
facility-type
Sets the facility type for remote
logging of syslog messages
GC 7-26
show logging Displays the state of logging Exec 7-27