SMC Networks 2.4GHz/5GHz Network Router User Manual


 
Command Line Interface
7-82
Command Usage
The access point uses a PPPoE connection, or tunnel, only for
management traffic between the access point and a remote
PPPoE server (typically at an ISP). Examples of management
traffic that may initiated by the access point and carried over a
PPPoE tunnel are RADIUS, Syslog, or DHCP traffic.
Example
pppoe ip allocation mode
This command specifies how IP addresses for the PPPoE tunnel
are configured on this interface.
Syntax
pppoe ip allocation mode {automatic | static}
automatic - IP addresses are dynamically assigned by the
ISP during PPPoE session initialization.
static - Fixed addresses are assigned by the ISP for both
the local and remote IP addresses.
Default Setting
automatic
Command Mode
Interface Configuration (Ethernet)
Command Usage
The IP address allocation mode depends on the type of
service provided by the ISP. If automatic mode is selected,
DHCP is used to allocate the IP addresses for the PPPoE
connection. If static addresses have been assigned to by the
ISP, these must be entered using the pppoe local ip and
pppoe remote ip commands.
AP#(if-ethernet)#ip pppoe
AP#