Filter
Top Products
Wireless Interface Commands
7-113
• To enable AES encryption, use the encryption command to
specify the key type, and use the key command to configure
a key for each wireless port.
• If WEP is enabled, all units in the wireless bridge network
must be configured with the same keys.
• The WEP key length specified in the encryption
command and the key command must match.
• The WEP key index, length and type configured on the local
wireless bridge must match those configured on other
wireless bridges.
• If AES is enabled, each wireless bridge link in the network
must be configured to use the same AES key
• The AES key type value entered using the key command
must be the same as the type specified in the encryption
command.
Example
Related Commands
encryption (page 7-110)
transmit-key
This command sets the index of the WEP key to be used for
encrypting data frames broadcast or multicast from the wireless
bridge.
Syntax
transmit-key <index>
index - Key index. (Range: 1-4)
Default Setting
1
AP(if-wireless a)#key wep 1 64 ascii 12345
AP(if-wireless a)#key wep 2 64 ascii abcde
AP(if-wireless a)#