Filter
Top Products
Entering Commands
7-7
Configuration Commands
Configuration commands are used to modify wireless bridge
settings. These commands modify the running configuration and
are saved in memory.
The configuration commands are organized into three different
modes:
• Global Configuration - These commands modify the system
level configuration, and include commands such as
username and password.
• Interface-Ethernet Configuration - These commands modify
the Ethernet port configuration, and include command such as
dns and ip.
• Interface-Wireless Configuration - These commands modify
the wireless port configuration, and include command such as
channel and encryption.
To enter the Global Configuration mode, enter the command
configure in Exec mode. The system prompt will change to
“AP(config)#” which gives you access privilege to all Global
Configuration commands.
To enter Interface mode, you must enter the “interface ethernet”
or “interface wireless a” command while in Global Configuration
mode. The system prompt will change to “AP(if-ethernet)#,” or
“AP(if-wireless a)” indicating that you have access privileges to
the associated commands. You can use the end command to
return to the Exec mode.
AP#configure
AP(config)#
AP(config)#interface ethernet
AP(if-ethernet)#