SMC Networks 2.4GHz/5GHz Network Router User Manual


 
Command Line Interface
7-124
Note: Before enabling VLANs on the wireless bridge, you must configure
the connected LAN switch port to accept tagged VLAN packets
with the wireless bridge’s native VLAN ID. Otherwise, connectivity
to the
wireless bridge will be lost when you enable the VLAN
feature.
The VLAN commands supported by the wireless bridge are listed
below.
vlan
This command enables VLANs for all traffic. Use the no form to
disable VLANs.
Syntax
vlan enable
no vlan
Default
Disabled
Command Mode
Global Configuration
Command Description
Changing the VLAN status of the wireless bridge forces a
system reboot.
When VLANs are enabled, the wireless bridge tags frames
received from wireless interface with the configured native
VLAN ID.
Traffic entering the Ethernet port must be tagged with a
VLAN ID that matches the wireless bridge’s native VLAN ID.
Command Function Mode Page
vlan Enables a single VLAN for all traffic GC 7-124
native-vlanid Configures the native VLAN for the
access point
GC 7-125