Filter
Top Products
92 Sun Fire V490 Server Administration Guide • August 2004
probe-ide Command
The probe-ide command communicates with all Integrated Drive Electronics (IDE)
devices connected to the IDE bus. This is the internal system bus for media devices
such as the DVD drive.
Caution – If you used the halt command or the Stop-A key sequence to reach the
ok prompt, then issuing the probe-ide command can hang the system.
The following is sample output from the probe-ide command.
CODE EXAMPLE 6-5 probe-ide Command Output
show-devs Command
The show-devs command lists the hardware device paths for each device in the
firmware device tree.
CODE EXAMPLE 6-6 shows some sample output (edited for
brevity).
CODE EXAMPLE 6-6 show-devs Command Output
ok probe-ide
Device 0 ( Primary Master )
Removable ATAPI Model: TOSHIBA DVD-ROM SD-C2512
Device 1 ( Primary Slave )
Not Present
/pci@9,600000
/pci@9,700000
/pci@8,600000
/pci@8,700000
/memory-controller@3,400000
/SUNW,UltraSPARC-IV@3,0
/memory-controller@1,400000
/SUNW,UltraSPARC-IV@1,0
/virtual-memory
/memory@m0,20
/pci@9,600000/SUNW,qlc@2
/pci@9,600000/network@1
/pci@9,600000/SUNW,qlc@2/fp@0,0
/pci@9,600000/SUNW,qlc@2/fp@0,0/disk