Sun Microsystems V490 Server User Manual


 
128 Sun Fire V490 Server Administration Guide August 2004
Install the server in the rack, following instructions in the Sun Fire V490 Server
Setup and Rackmounting Guide.
What to Do
1. Locate the RJ-45 twisted-pair Ethernet (TPE) connector for the appropriate
Ethernet interface—the top connector or the bottom connector.
See “Locating Back Panel Features” on page 16. For a PCI Ethernet adapter card, see
the documentation supplied with the card.
2. Connect a Category-5 unshielded twisted-pair (UTP) cable to the appropriate
RJ-45 connector.
You should hear the connector tab click into place. The UTP cable length must not
exceed 100 meters (328 feet).
3. Connect the other end of the cable to the RJ-45 outlet to the appropriate network
device.
You should hear the connector tab click into place.
Consult your network documentation if you need more information about how to
connect to your network.
What Next
If you are installing your system, complete the installation procedure. Return to
Chapter 1.
If you are adding an additional network interface to the system, you need to
configure that interface. See:
“How to Configure Additional Network Interfaces” on page 146