Sun Microsystems V490 Server User Manual


 
Chapter 7 Configuring Console Access 123
4. Insert the system key into the system control switch and turn the system control
switch to the Normal position.
See “System Control Switch” on page 15 for information about each system control
switch setting.
5. Press the Power button that is below the system control switch to power on the
system.
Note The system may take anywhere from 30 seconds (if firmware diagnostics do
not run) to almost 30 minutes before video is displayed on the system monitor or the
ok prompt appears on an attached terminal. This time depends on the system
configuration (number of processors, memory modules, PCI cards) and the level of
power-on self-test (POST) and OpenBoot Diagnostics tests being performed.
Media door
N
ormal position
Power button