Filter
Top Products
Media Handling
Laminating Station
980541-001 Rev. A P640i Card Printer User Guide 17
2. Grasp the cassette and pull it straight
toward you, clear of the printer.
3. Open the cassette, like a clam shell, by
separating its two halves. Grasp the two
halves firmly with the fingers, then pull.
Do NOT use tools to pry it apart.
Loading the cassettes
1. Discard the spent core. Hold the open
cassette with its cavities toward you,
white idler wheel to the top.
2. Place a roll of laminate in the cassette so that it feeds from the bottom of the roll, UP and
OUT to the front. Pull out an inch or two of laminate.
Caution • If you feel resistance when
removing the cassette, the laminate has likely
run out, leaving one end attached to the core
and the other end under the cutter. Keep
tugging on cassette, which will come free with
a short tail of laminate.
Caution • Remove the transfer guide to be
sure there are no scraps of laminate
remaining.
Caution • You need partial width laminate for
the LOWER cassette if there is a mag stripe
or signature stripe on the card
Caution • If the lower cassette is intended for
partial width laminate, it will have an edge
guide to keep the laminate on track. Make
sure it is in the correct position for the partial
width laminate you are using.