Filter
Top Products
80 P640i Card Printer User Guide 980541-001 Rev. A
6. When the Configure Ethernet Port screen
reappears, click Configure Printer.
7. Leave DHCP set to OFF. Type in the IP address,
Netmask and Gateway codes provided by your
network administrator, then click OK.
8. Check the Static IP address reported on the
Configure Ethernet Port screen. If correct, click
OK. If not, click Configure Printer again to repeat
the process.
9. This screen reminds you to select the correct port
when it is asked for by the Printer Wizard.
10. From this point on the Add Printer Wizard will
complete the installation semi-automatically.
Check each screen to be sure the checked items
are correct before moving on to the next.
11. Select Local printer.
Note • The IP address shown below is for
illustration only.