Filter
Top Products
Dimension ES-2008 Ethernet Switch
16-8 Protocol Related Configuration
Figure 16-13 SMT: LACP Group Setting
Before you configure LACP, you must set the trunk groups first.
Refer to the chapter on Port Trunking.
The following table describes the fields in this screen.
Table 16-2 SMT: LACP Group Setting
FIELD DESCRIPTION
Group This read-only field displays the trunk group number.
LACP
Press [SPACE BAR] and [ENTER] to select Enable to activate
dynamic trunking on this trunk group.
Work Port No. Enter the number of ports in the trunk group.
If dynamic trunking is not activated on the trunk group then the
number must be the same as the number of ports in the trunk
group.
If dynamic trunking is activated, you may enter a number bigger
than the number of ports in a trunk group.
Press [ESC] to move the cursor back to the actions menu. Press [TAB] to select <Save>
and press [ENTER] to save the settings back to the switch.
Dimension Switch ES-2008 : LACP Group Setting
========================
Group LACP Work Port No.
------------------------------------------
Trk1. Enabled 2
Trk2. Disabled 2
actions-> <Edit> <Save> <Quit>
Select the action menu.
Tab=Next Item BackSpace=Previous Item Quit=Previous menu Enter=Select Item