Filter
Top Products
Dimension ES-2008 Ethernet Switch
Switch Configuration 15-1
Chapter 15
Switch Configuration
This chapter introduces various switch configurations.
15.1 Port and Trunk Group Settings
Refer to the Port Trunking chapter for background information on trunking.
Follow the steps below to configure port parameters and set up trunk groups.
Step 1. In the Switch Configuration screen, select Port/Trunk Configuration and
press [ENTER] to display the screen as shown next.
Step 2. Select <Edit> in the actions menu and press [ENTER] to move the cursor to
the configuration fields.
Figure 15-1 SMT: Port/Trunk Configuration
Follow the instructions in the next table to set the fields in this screen.
Table 15-1 SMT: Port/Trunk Configuration
FIELD DESCRIPTION
Port This read-only field displays the port number (from 1 to 9 including the
fiber/gigabit port) on the switch.
Dimension Switch ES-2008 : Port/Trunk Configuration
========================
Port Type Enabled Auto Speed/Duplex Flow Group
Negotiate Config Control
---------------------------------------------------------------------------
1. 10/100TX Yes Enabled 100 Full On None
2. 10/100TX Yes Enabled 100 Full On None
3. 10/100TX Yes Enabled 100 Full On None
4. 10/100TX Yes Enabled 100 Full On Trunk1
5. 10/100TX Yes Enabled 100 Full On Trunk2
6. 10/100TX Yes Enabled 100 Full On Trunk2
7. 10/100TX Yes Enabled 100 Full On Trunk1
8. 10/100TX Yes Enabled 100 Full On Trunk1
9. 100FX Yes Disabled 100 Full On N/A
actions-> <Quit> <Edit> <Save>
Select the Action menu.
Tab=Next Item BackS
p
ace=Previous Item Quit=Previous menu Enter=Select Item