Filter
Top Products
Connecting the Remote Wake-Up Cable 27
Note the slot number of the NIC. You may need it during
driver installation.
If you are installing the Remote Wake-Up cable, go to the
next section, “Connecting the Remote Wake-Up Cable,” to
continue the installation. If you are not installing the cable,
continue with step 4.
4 Replace the unit’s cover and reconnect any cables that
you may have disconnected from other devices (see
“Safety Precautions”).
Do not turn on the power to the PC.
5 Go to “Connecting to the Network” later in this
chapter.
Connecting the Remote Wake-Up Cable
Connecting the Remote Wake-Up cable is optional.
Connect this cable only if your PC supports
Remote Wake-Up and you want to use this feature.
Your PC may conform to new PCI standards that eliminate
the need for a Remote Wake-Up cable to deliver power to
the 3C359B NIC. If your PC has PCI bus power
management, then there is no need to install the cable. See
your PC’s system documentation for complete information.
WARNING: Make sure that the PC power cord is
unplugged. Only properly trained and authorized personnel
should perform service. Contact your PC manufacturer
for information about safe service techniques.
To connect the Remote Wake-Up cable:
1 Make sure that the NIC is properly installed in a PCI slot.
2 Insert the Remote Wake-Up cable included in your
package into the connector on the NIC (see Figure 3).
3 Attach the cable to the connector on the PC
motherboard (see Figure 3).
Refer to your PC documentation if you need help with
locating the connector.