Filter
Top Products
Installing a NetWare Server Driver 45
The modules on TokenDisk diskette 2 (or in the \DISK_2
directory on the TokenLink Velocity CD) are version 2.50.
You can load the server driver as described later in this
chapter in “Using the LOAD Command.”
CAUTION: Using versions of MSM.NLM, MSM31X.NLM,
and TOKENTSM.NLM earlier than 2.50 with TLNKPODI.LAN
prevents the driver from loading.
Replacing Support Modules To replace support
modules with more recent versions, use the steps below
to load the support modules from the TokenDisk diskette
and copy them to the file server.
Instructions in this section are written for TokenDisk
diskettes. If you are using the TokenLink Velocity XL CD,
substitute the appropriate path (using the \DISK_2
designation at the start of the path) where required.
1 Use the Unload command from the console command
prompt to unload any existing server drivers that
depend on the support modules you need to replace.
This command will completely unload the drivers from
memory and will terminate communication with currently
attached network users.
The format of the command is:
unload <driver_name>
2 Unload the support modules by entering the
commands in the order shown below:
unload tokentsm
unload msm
3 Load the support modules from TokenDisk diskette 2.
Enter the following commands when the diskette is
in drive A. Use a different drive if necessary:
NetWare 4.1x and 5.0 servers:
load a:\netware\nwserver\41x_5.0\nbi
load a:\netware\nwserver\41x_5.0\msm
load a:\netware\nwserver\41x_5.0\tokentsm
NetWare 3.12 servers:
load a:\netware\nwserver\3.12\nbi31x
load a:\netware\nwserver\3.12\msm31x
load a:\netware\nwserver\3.12\tokentsm
load a:\netware\nwserver\3.12\monitor