Filter
Top Products
Installing a DOS 16-Bit Client Driver 35
If you are using the TokenLink Velocity XL CD, insert
it in the CD-ROM drive and enter the location of the
DOS 16-bit client driver:
<drive>\disk_2\netware\nwclient
5 Select 3Com TokenLink Velocity XL PCI and press
Enter.
The program copies all relevant files and makes required
changes to the AUTOEXEC.BAT and CONFIG.SYS files.
6 Copy the microcode file TLNKP.MAC to the NetWare
client directory on the hard drive.
■ If you are using the 3.5-inch TokenDisk diskettes, enter:
copy a:\tlnkp.mac c:\nwclient
■ If you are using the TokenLink Velocity XL CD, substitute
the appropriate drive and DISK_2 designation in the
path as follows:
copy d:\disk_2\tlnkp.mac c:\nwclient
7 Restart your PC to start the NetWare 16-bit client.
This completes the procedure for manually installing a
NetWare DOS 16-bit client driver.
Configuring the DOS 16-Bit Client Driver
You can edit the NET.CFG file to change the ring speed or
transmit/receive mode. Follow these steps:
1 Using a word processor or text editor, such as the
DOS Editor, open the C:\NWCLIENT\NET.CFG file.
2 Scroll through the file and locate the following lines:
LINK DRIVER TLNKPODI
3 Add the appropriate keywords as shown below.
LINK DRIVER TLNKPODI
ringspeed <auto | 4 | 16>
<classic | dtr>
where RINGSPEED AUTO forces the driver to detect the
current ring speed and to connect at that speed. The
default setting is AUTO. You do not need to specify the
AUTO setting; it is automatically enabled. If the connection
fails, try one of the other speed settings: 4 or 16. A setting
of 4 forces the driver to always open the connection at