Filter
Top Products
Installing DOS Client32 37
■ If you are using the TokenDisk diskette (in Drive A for
example), enter the following path:
a:\netware\client32
■ If you are using the TokenLink Velocity XL CD (in Drive D
for example), enter the following path using the
appropriate DISK_2 designation as follows:
d:\disk_2\netware\client32
9 Select TokenLink Velocity XL PCI and press Enter.
The system allows you to change the configuration.
10 To change a parameter, select it and press Enter. Type
the new value. When you are finished changing
parameters, press Enter.
11 When the path for the configuration files is
displayed, verify that the path is correct and
press Enter.
12 Press Enter again to return to DOS and edit the
STARTNET.BAT file.
13 Add the NIC’s slot number in the STARTNET.BAT file
as follows:
load c:\novell\client32\tlnkpodi.lan
frame=token-ring msb slot=<nnnn>
where <nnnn> is the slot number.
If you do not know your NIC’s slot number, you can turn off
your PC, remove the cover, and check the slot.
14 On the same LOAD line, you can set the NIC’s ring
speed as follows.
load
c:\novell\client32\tlnkpodi.lan...ringspeed=<a
uto | 4 | 16>
where <auto | 4 | 16> is the ring speed setting:
■ Auto — Allows the NIC to automatically detect the ring
speed. (This is the default setting.)
■ 4 — Disables auto ring speed detection and sets the
NIC ring speed at 4 Mbps.
■ 16 — Disables auto ring speed detection and sets the
NIC ring speed at 16 Mbps.