Filter
Top Products
90 CHAPTER 5: IBM ENVIRONMENTS
Using IBM MPTS to Install a Driver for OS/2
If your OS/2 network operating system has not yet been
installed on your computer, install it now and follow its
instructions for installing device drivers. If an OS/2 network
operating system has previously been installed, follow the
instructions here for using IBM Multiprotocol Transport
Services (MPTS) to install device drivers.
1 Start IBM MPTS by performing either of the
following actions:
■ From the OS/2 desktop, double-click the MPTS icon.
■ From an OS/2 window, go into the IBMCOM
subdirectory and at the OS/2 prompt, enter:
mpts
2 Select OK on the MPTS logo panel.
3 Select Install.
You are prompted for the source of the NIF file.
4 If you are using diskettes, insert TokenDisk diskette 2
in a drive (for example, drive A) and enter:
a:\ndis2\os2
If you are using the TokenLink Velocity XL CD, insert
it in the CD-ROM drive (for example, drive D) and
enter:
d:\disk_2\ndis2\os2
5 When the Installation Complete message appears,
select OK.
You are returned to the main menu.
6 Select Configure in the MPTS dialog box.
7 In the Configure panel, verify that LAN Adapters and
protocols is preselected, and then select Configure at
the bottom of the panel.
8 In the Configure panel in the Network Adapters
group box, select 3Com TokenLink Velocity XL PCI
and click ADD.
You can edit parameter settings for the 3C359B NIC. Select
the 3C359B NIC in the Current Configuration list box and
click Edit. When you are finished with the parameter
settings, click OK.