Filter
Top Products
34 CHAPTER 3: NOVELL NETWARE ENVIRONMENTS
If you experience problems using Intelligent Auto Install,
see the next section, “Intelligent Auto Install
Troubleshooting.” If you cannot connect to the NetWare
server after running Intelligent Auto Install, see Chapter 6,
“Troubleshooting.”
Intelligent Auto Install Troubleshooting
If you experience problems when using the Intelligent Auto
Install program, display or print the COMSLINK.LOG file,
which contains a log of the events that occurred during
the Intelligent Auto Install program installation and
configuration process.
1 To display the file, enter the following DOS
command:
type comslink.log | more
2 To print the file, connect to a local printer and enter:
copy comslink.log prn
or
print comslink.log
Installing a DOS 16-Bit Client Manually
If you did not use the Intelligent Auto Install utility, follow
these steps to install the DOS 16-bit client driver for
NetWare:
1 Insert the Novell NetWare Client for DOS and
Microsoft Windows Disk 1 and make that drive the
active drive. For example, enter:
a:
2 Enter the following command:
install
Follow the displayed instructions as they appear.
3 When prompted to select the driver for your network
board, scroll down through the list titled Network
Boards. Select Other Drivers, and press Enter.
4 If you are using the 3.5-inch TokenDisk diskettes,
insert TokenDisk diskette 2 in the drive and make
that drive the active drive. For example, enter:
a: