Filter
Top Products
46 CHAPTER 3: NOVELL NETWARE ENVIRONMENTS
Copying Support Modules and the Driver to the
File Server This section explains how to copy support
modules and TLNKPODI.LAN to the file server. If you have
replaced existing support modules, follow this procedure,
so that the most current versions of the support modules
load whenever you load a server driver.
The SYS volume on the file server must be mounted, you
must have rights to copy files to the SYS:SYSTEM directory,
and at least one server driver must be loaded and bound to
a protocol.
Instructions in this section are written for TokenDisk
diskettes. If you are using the TokenLink Velocity XL CD,
substitute the appropriate path (using the \DISK_2
designation at the start of the path) where required.
1 Locate a workstation with a diskette drive. This
workstation must allow you to log in to the file
server to which you will copy the NLMs.
2 Log in to the file server. Insert TokenDisk diskette 2 in
the drive and copy the support files to the server.
If drive F is mapped to the SYS volume, the sample
commands shown below copy files from a diskette in the
workstation’s drive A to a NetWare 4.1x file server:
copy a:\netware\nwserver\41x_5.0\msm.nlm
f:\system
copy a:\netware\nwserver\41x_5.0\tokentsm.nlm
f:\system
3 Enter the following command to copy the
TLNKPODI.LAN server driver to F:SYS:SYSTEM:
copy a:\netware\nwserver\41x_5.0\tlnkpodi.lan
f:\system
Using the LOAD Command You can enter the LOAD
command from the server's console command prompt or
you can include it in your AUTOEXEC.NCF file to load the
driver automatically when you start the SERVER program.
The format of the command is shown below:
load <path>\tlnkpodi <parameter_list>
where <path> is the full pathname to the location of
TLNKPODI.LAN, if it is not at SYS:SYSTEM.