Filter
Top Products
92 CHAPTER 4: USING RF AUTO-TUNING
Place Your
Equipment
You will need to unpack and physically install your WX switches and
MAPs. For information about installing your equipment, see “Equipment
Installation” on page 42.
Configure Initial
WX Switch
Connectivity
After installing a WX switch, you must use the command-line interface
(CLI) to prepare it for configuration and management by 3WXM. Use the
Web Quick Start (if available), or enter the quickstart command at the
CLI prompt. From there, you will:
Configure IP connectivity between the WX and 3WXM.
Enable secure communication between the WX and 3WXM or the
Web browser by installing certificates from a certificate authority (CA)
or a self-generated certificate.
For more information about configuring initial WX switch connectivity,
see the Wireless LAN Switch and Controller Installation and Basic
Configuration Guide.
Upload the WX
Switch
Configuration into
a 3WXM Network
Plan
Retrieve the basic configuration information you added to the WX switch
and upload it into 3WXM.