Filter
Top Products
SNC 5100
2Safety Notices
6-00020-02
Remove AC Power
If the SNC 5100 is not powered off, perform the following steps to remove AC
power.
Step 1. Perform a controlled system shutdown of attached host systems.
Step 2. Set the Power switch on the SNC 5100 to the off position.
Step 3. Disconnect the power cord from the power source.
External Machine Check
Perform the following external machine check:
Step 1. Verify that the external cover and front bezel of the unit are present
and not damaged.
Step 2. Check the power cord for damage.
Step 3. Check the external signal cable for damage.
Step 4. Check the cover for sharp edges, damage, or alterations that expose
the internal parts of the device.
Step 5. Correct any problems that you find.
Safety Label Check
Perform the following label check:
Step 1. Verify that the safety label shown in Figure 1 is installed on the
SNC 5100.
Figure 1 Safety Label