Filter
Top Products
Commands 135
6-00020-02
SNC 5100
hlthChkLevelGet
To display the current Health Check level, use the
hlthChkLevelGet
command. The example below shows that the current level is 2.
SN60023 > hlthChkLevelGet
value=2=0x02
SN60023 >
hlthChkLevelSet
To set the Health Check level, use the
hlthChkLevelSet command. The
example below shows setting the level to 3.
SN60023 > hlthChkLevelSet 3
value=0=0x0
SN60023 >
hlthChkNow
The
hlthChkNow function causes the SNC 5100 to execute an immediate, level
4 Health Check. Results are displayed that will indicate which devices or
subsystems failed the check.
SN60023 > hlthChkNow
Health Check: Starting level 4 check
Health Check: Step 1 -- Checking System
Health Check: Step 2 -- Checking Interfaces
Health Check: Step 3 -- Checking Devices
Health Check: Step 4 -- Checking Device States
Health Check: Passed
value=0=0x0
SN60023 >
host “add”,“hostname”,“ipAddress”
The host “add” command adds the named host to the host table and host file.
If the IP address is already assigned to a host, then the new name is added as an
alias for the host. The
host “add” command is invoked to add known hosts
and their IP addresses. Alias names are supported, allowing multiple names to
a single host.
The host utilities maintain a host file, nvfs:/mgnt/hosts, which is used