Filter
Top Products
SNC 5100
184 Commands
6-00020-02
value = 15 = 0xf
SN60023C >
uptime
The
uptime command displays the elapsed time since the last boot of the SNC
5100.
SN60023 > uptime
Elapsed time since reset 4d:23h:12m:46s:10t
value = 10 = 0xa
SN60023 >
The example indicates that 4 days, 23 hours, 12 minutes, 46 seconds and 10
clock ticks have elapsed since the SNC 5100 was last booted. There are 60
ticks per second.
user
The userAdd,userDelete, and userList commands provide control of the
user list. The persistent address map file can be sent to the SNC 5100 or
retrieved from it using FTP. If you need to use FTP, use the user commands to
create a login and password so you can access the SNC 5100 from the Ethernet
network.
userAdd “username”,”password”
The userAdd command adds a user and password to the password file. The
parameter “username” must be from 3 to 80 characters. The parameter
“password” must be from 8 to 40 characters.
SN60023 > userAdd "nancy","password"
value=0=0x0
SN60023 >
userDelete “username”,”password”
The
userDelete command deletes a user from the password file. It is not
possible to remove a user without knowing the user’s password. If the user’s
password is forgotten or unknown, you have to delete the password file, reboot
the SNC 5100, and then add all user names and passwords again.
SN60023 > userDelete "nancy","password"