Filter
Top Products
Commands 163
6-00020-02
SNC 5100
interface. This provides some customization in the way the SNC 5100 is
presented to the particular operating system. If [port] is 0, the change applies to
all SAN connections; otherwise the host type is applied to the specified port.
Caution
You must reboot the SNC 5100 after executing this command for
the new setting to take effect.
setNettime [value]
The
setNettime command enables or disables timeserver functionality.
Parameter Value
Port 0 Changes will apply to all FC
Connections
1 or 2 Changes will apply to FC Connection 1
or 2, as specified
OS “nt”
“aix”
“solaris”
“hp-ux”
“linux”
“netware”
“gateway”
“generic”
“unisys”
“as400”
“adic snc”
“pv-136t-fc”
“autosense/nt”
Value Meaning
0 Disables timeserver functionality
1 Enables timeserver functionality