Filter
Top Products
Commands 129
6-00020-02
SNC 5100
controller.
Loop ID The Fibre Channel Loop ID for this interface.
PtoP indicates a point-to-point connection.
Fabric Attached Indicates whether the port is attached to a Fabric.
Port Mode Indicates whether the port is set to Target or
Initiator mode
Ext. FIFO Indicates that FIFOs external to the FC controller
are on the board. If they are, their size in KB will
be output into this column.
Link Speed Indicates the actual speed of the connection. This
figure is only meaningful when the Firmware
State is reported as Ready.
Caution
If the Firmware State is anything but Ready, the information
output by this command will be unreliable.
fcShowDevs
The
fcShowDevs command displays information about the devices that are
accessible from each Fibre Channel interface. The display shows the LUN that
the SNC 5100 has assigned to each device, the SCSI Channel that the device is
attached to, the actual SCSI ID and LUN of the device, the vendor, product,
revision and serial number of the device.
In the example, Channel Zoning was used for access control. Fibre Channel 1
has access to all of the attached SCSI tape devices. For the other Fibre Channel
interface, Channel Zoning has been setup to restrict access to certain devices.
SN60023 > fcShowDevs
FC 1:
LUN Chan Id Lun Vendor Product Rev SN
-----------------------------------------------------
0000ADIC0338 00000060450d0080
17300OEM 03570C12 5346 000000000305
18301OEM 03570C12 5346 000000000305
19310OEM 03570C12 5346 000000000306
6110OEMOEMDCHS04X 6363 681F775B
7120OEMOEMDCHS04X 6363 682086D3
8230OEMOEMDCHS04X 6363 6820837B
9240OEMOEMDCHS04X 6363 682076AC
FC 2:
LUN Chan Id Lun Vendor Product Rev SN
-----------------------------------------------------