Filter
Top Products
Ethernet MAP 69
6-00020-02
SNC 5100
Step 1. Verify that the SNC 5100 is plugged into an active AC power
source.
Step 2. Verify the status of the SNC 5100 Power LED.
For more information, go to Figure 4 on page 14.
Step 3. If the Power LED remains off, try a different power cord.
Step 4. If the Power LED remains off, remove the SNC 5100.
Proceed to “Before Removing or Replacing the Unit” on page 82.
Continue through “Replacing the SNC 5100” on page 84.
Ethernet MAP
The network administrator must provide the following information before you
can perform this MAP:
• The IP address for the SNC 5100 - REQUIRED
• The net mask for the SNC 5100 in decimal and hex formats - REQUIRED
• The network gateway IP address for the SNC 5100 - if assigned
• The IP address of a computer on the same subnet as the SNC 5100 for
PING tests - REQUIRED
• The IP address of the ADIC Management Console Server - REQUIRED.
For more information, see the ADIC Management Console User Guide.
Step 1. The SNC 5100 must be booted and its Ethernet Port must be
attached to the local area network.
For the position of the Ethernet port on the SNC 5100, see Figure 7.
Figure 7: Ethernet Port on Faceplate