Filter
Top Products
4-60 Agilent 87130A Operating and Service Manual
Remote Operation
STATus
STATus
Syntax
STATus:OPERation
STATus:QUEStionable
Description
The STATus subsystem is fully specified by SCPI. Refer to the following
commands:
*STB (Status Byte), *SRE (Request Enable), *ESE
(Event Status Enable), and *ESR? (Event Status Register Query)
• STATus:OPERation
In the STATus:OPERation subsystem, only the settling bit (bit 1) is
implemented by the 87130A; it is set during a switching operation (and
when saving to EEROM) and cleared when it completes. The
“SWITCHING” LED is on whenever this bit is set. The following
commands are applicable:
❍ STATus:OPERation:EVENt
❍ STATus:OPERation:CONDITION?
❍ STATus:OPERation:ENABle
❍ STATus:OPERation:PTRansition[?]
❍ STATus:OPERation:NTRansition[?]
❍ STATus:OPERation:PTRansition[?]
• STATus:QUEStionable
The QUEStionable susbsytem is required by SCPI but is not used by the
87130A, 70612A,C or 70613A,C. The following commands are
implemented:
❍ STATus:QUEStionable:EVENt?
❍ STATus:QUEStionable:CONDition?
❍ STATus:QUEStionable:ENABle
:[EVENt]?
:CONDition
:ENABle[?]
:PTRansition
:NTRansition[?]
:[EVENt]?
:CONDition?
:ENABle[?]