Filter
Top Products
Agilent 87130A Operating and Service Manual 4-67
Remote Operation
:WIDTh
:WIDTh
Syntax
ROUTe:WIDTh <pulse width>,
ROUTe:WIDTh <channel list>
Description
This command sets the pulse width in seconds required to close a relay. The
pulse width may be set in 5 ms increments up to 1275 ms. The pulse width
defaults to 30 ms when memory is initialized. The
WIDTh parameter may be
an integer or a real number.
Example Command ROUTE:WIDTH .03,(@101,103,105);
In the above example, the pulse width is set to 30 ms for channels 1, 3, and 5.
ROUTE:WIDTH .03,ATTEN_14;
This command causes the drive with to the set of relays (defined by the
ROUTe:PATH command) with path name ATTEN_14 to be set to the specified
pulse width. If the path includes two channel lists, all relays in both lists are
affected.
Example Query ROUTE:WIDTH? (@101,103,105);
In this case, the pulse width for channels 101, 103 and 105 is read back, with
the values separated by commas. For example, if all three are set to 30 ms,
then the readback is:
+3.000E-02,+3.000E-02,+3.000E-02
The query form is not available when using a path name, due to the potential
for confusion between the first group and the second in the path.
<channel list>
<path name>