Filter
Top Products
Enabling QinQ Tunneling on the Switch
The switch can be configured to operate in normal VLAN mode or IEEE 802.1Q
(QinQ) tunneling mode which is used for passing Layer 2 traffic across a service
provider’s metropolitan area network. You can also globally set the Tag Protocol
Identifier (TPID) value of the tunnel port if the attached client is using a nonstandard
2-byte ethertype to identify 802.1Q tagged frames.
Command Usage
• Use the TPID field to set a custom 802.1Q ethertype value on the selected
interface. This feature allows the switch to interoperate with third-party switches
that do not use the standard 0x8100 ethertype to identify 802.1Q-tagged frames.
For example, if 0x1234 is set as the custom 802.1Q ethertype on a trunk port,
incoming frames containing that ethertype are assigned to the VLAN contained in
the tag following the ethertype field, as they would be with a standard 802.1Q trunk.
Frames arriving on the port containing any other ethertype are looked upon as
untagged frames, and assigned to the native VLAN of that port.
• All ports on the switch will be set to the same ethertype.
Command Attributes
• 802.1Q Tunnel Status – Sets the switch to QinQ mode, and allows the QinQ
tunnel port to be configured. The default is for the switch to function in normal
mode.
•
802.1Q Ethernet Type
– The Tag Protocol Identifier (TPID) specifies the ethertype
of incoming packets on a tunnel port. (Range: hexadecimal 0800-FFFF;
Default: 8100)
Web
– Click VLAN, 802.1Q VLAN, 802.1Q Tunnel Configuration. Check the Enabled
box, set the TPID of the ports if the client is using a non-standard ethertype to
identify 802.1Q tagged frames, and click Apply.
Figure 11-1 802.1Q Tunnel Status and Ethernet Type
11-16
VLAN Configuration
11