Filter
Top Products
Command Usage
• Domain names are added to the end of the list one at a time.
• When an incomplete host name is received by the DNS service on this switch,
it will work through the domain list, appending each domain name in the list to
the host name, and checking with the specified name servers for a match.
• If there is no domain list, the domain name specified with the
ip domain-name
command is used. If there is a domain list, the default domain name is not used.
Example
This example adds two domain names to the current list and then displays the list.
Console(config)#ip domain-list sample.com.jp
Console(config)#ip domain-list sample.com.uk
Console(config)#end
Console#show dns
Domain Lookup Status:
DNS disabled
Default Domain Name:
.sample.com
Domain Name List:
.sample.com.jp
.sample.com.uk
Name Server List:
Console#
Related Commands
ip domain-name (38-3)
ip name-server
This command specifies the address of one or more domain name servers to use for
name-to-address resolution. Use the
no
form to remove a name server from this list.
Syntax
[
no
]
ip name-server
server-address1 [server-address2 … server-address6]
• server-address1 - IP address of domain-name server.
• server-address2 … server-address6 - IP address of additional
domain-name servers.
Default Setting
None
Command Mode
Global Configuration
Command Usage
The listed name servers are queried in the specified sequence until a
response is received, or the end of the list is reached with no response.
38-4
Domain Name Service Commands
38