Filter
Top Products
Command Group Function
Device Designation Configures information that uniquely identifies this switch
System Status Displays system configuration, active managers, and version information
Frame Size Enables support for jumbo frames
File Management Manages code image or switch configuration files
Line Sets communication parameters for the serial port, including baud rate and
console time-out
Event Logging Controls logging of error messages
SMTP Alerts Configures SMTP email alerts
Time (System Clock) Sets the system clock automatically via NTP/SNTP server or manually
Device Designation Commands
This section describes commands used to configure information that uniquely
identifies the switch.
Table 23-2 Device Designation Commands
Chapter 23: System Management Commands
These commands are used to control system logs, passwords, user names,
management options, and display or configure a variety of other system information.
Table 23-1 System Management Commands
Page
23-1
23-3
23-9
23-10
23-17
23-26
23-32
23-35
Command Function
hostname Specifies the host name for the switch
snmp-server contact Sets the system contact string
snmp-server location Sets the system location string
switch renumber Renumbers stack units
Mode Page
GC 23-1
GC 24-4
GC 24-4
PE 23-2
hostname
This command specifies or modifies the host name for this device. Use the no form
to restore the default host name.
Syntax
hostname
name
no hostname
name - The name of this host. (Maximum length: 255 characters)
Default Setting
None
23-1