Filter
Top Products
Example
This example creates a policy called “rd_policy,” uses the
class
command to specify
the previously defined “rd_class,” uses the
set
command to classify the service that
incoming packets will receive, and then uses the
police
command to limit the
average bandwidth to 100,000 Kbps, the burst rate to 1522 bytes, and configure the
response to drop any violating packets.
Console(config)#policy-map rd_policy
Console(config-pmap)#class rd_class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police 100000 1522 exceed-action drop
Console(config-pmap-c)#
service-policy
This command applies a policy map defined by the
policy-map
command to the
ingress queue of a particular interface. Use the
no
form to remove the policy map
from this interface.
Syntax
[
no
]
service-policy
input
policy-map-name
• input - Apply to the input traffic.
• policy-map-name - Name of the policy map for this interface.
(Range: 1-16 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Only one policy map can be assigned to an interface.
• First define a class map, then define a policy map, and finally use the
service-policy
command to bind the policy map to the required interface.
• The switch does not allow a policy map to be bound to an interface for egress
traffic.
Example
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd_policy
Console(config-if)#
36-8
Quality of Service Commands
36